Configuring Network Threat Protection in the Web Console
In the Web Console, you can configure Network Threat Protection settings in the policy properties (Application settings → Essential Threat Protection → Network Threat Protection).
Network Threat Protection component settings
Setting |
Description |
|---|---|
Network Threat Protection enabled / disabled |
This toggle button enables or disables Network Threat Protection. The check toggle button is switched on by default. |
Action on threat detection |
Actions performed upon detection of network activity that is typical of network attacks.
|
Blocking attacking devices enabled / disabled |
This toggle button enables or disables blocking network activity when a network attack attempt is detected. The check toggle button is switched on by default. |
Block the attacking device for (min) |
In this field you can specify the duration an attacking device is blocked in minutes. After the specified time, Kaspersky Embedded Systems Security allows network activity from this device. Available values: integer from 1 to 32768. Default value: 60. |
Exclusions |
The table contains a list of IP addresses. Network attacks from these addresses will not be blocked. By default, the list is empty. |
IP address window
In this window, you can add and edit IP addresses. Network attacks from these IP addresses will not be blocked by Kaspersky Embedded Systems Security.
IP addresses
Setting |
Description |
|---|---|
Enter an IP address |
Entry field for an IP address. You can specify IP addresses in IPv4 and IPv6 formats. |