Specifying the address of a CPE device

To specify the address of a CPE device:

1. In the menu, go to the SD-WAN section.

   By default, the CPE subsection is displayed with a table of CPE devices.

2. Click the CPE device.

   The settings area is displayed in the lower part of the page. You can expand the settings area to fill the entire page by clicking the expand button .

3. In the upper part of the settings area, under Actions click Set location.
4. This opens a window; in that window, enter the address of the CPE device's location. As you enter the address, you are prompted to select an address from a drop-down list.

   The address is displayed on the map.

5. Click Save.

Page top