Kaspersky SD-WAN

Managing IP multicast transport services

To display the table of IP multicast services, go to the Infrastructure menu section, click Management → Configuration menu next to the controller, and go to the IP multicast services section. Information about IP multicast services is displayed in the following columns of the table:

• Name is the name of the IP multicast service.
• Source port contains information about the source service interface of the IP multicast service:
  • Name and DPID of the CPE device on which the service interface was created
  • The number of the OpenFlow port which the service interface is mapped to.
• Backup source port contains information about the backup source service interface of the IP multicast service:
  • Name and DPID of the CPE device on which the service interface was created
  • The number of the OpenFlow port which the service interface is mapped to.
• Querier IP is the IP address of the source service interface of the IP multicast service.
• Consumer ports contains information about the destination service interfaces of the IP multicast service:
  • Names and DPIDs of the CPE devices on which the service interfaces were created
  • Numbers of OpenFlow ports which the service interfaces are mapped to
• Groups contains information about multicast groups that have been added to the IP multicast service:
  • IP addresses of multicast groups
  • Prefix lengths of multicast groups
  • Guaranteed bandwidth for multicast groups
• Status is the status of the IP multicast service:
  • Up
  • Down
• Errors are errors that occurred while the IP multicast service was running.

The actions you can perform with the table are described in the Managing solution component tables instructions.