Disabling or enabling an IP set

You can disable or enable an IP set in a firewall template or on a CPE device. An IP set enabled or disabled in a firewall template is automatically enabled or disabled on all CPE devices that use this firewall template.

To disable or enable an IP set:

1. Disable or enable an IP set in one of the following ways:
   • If you want to enable or disable an IP set in a firewall template, go to the SD-WAN → Firewall templates menu section, click the firewall template, and select the IP sets tab.
   • If you want to enable or disable an IP set on a CPE device, go to the SD-WAN → CPE menu section, click the CPE device, select the Firewall settings → IP sets tab, and select the Override check box.

   A table of IP sets is displayed.

2. Click Disable or Enable next to the IP set that you want to disable or enable.

   The IP set is disabled or enabled.

3. In the upper part of the settings area, click Save to save the settings of the firewall template or CPE device.