Disabling or enabling a DNAT rule

You can disable or enable a DNAT rule in a firewall template or on a CPE device. A DNAT rule enabled or disabled in a firewall template is automatically enabled or disabled on all CPE devices that use this firewall template.

To disable or enable a DNAT rule:

1. Disable or enable a DNAT rule in one of the following ways:
   • If you want to disable or enable a DNAT rule in a firewall template, go to the SD-WAN → Firewall templates menu section, click the firewall template and in the displayed settings area, select the NAT → DNAT tab.
   • If you want to disable or enable a DNAT rule on a CPE device, go to the SD-WAN menu section → CPE, click the CPE device, in the displayed settings area, select the Firewall settings → NAT → DNAT tab and select the Override check box.

   A table of DNAT rules is displayed.

2. Click Disable or Enable next to the DNAT rule that you want to disable or enable.

   The DNAT rule is disabled or enabled.

3. In the upper part of the settings area, click Save to save the settings of the firewall template or CPE device.