Disabling or enabling a SNAT rule

You can disable or enable a SNAT rule in a firewall template or on a CPE device. A SNAT rule enabled or disabled in a firewall template is automatically enabled or disabled on all CPE devices that use this firewall template.

To disable or enable a SNAT rule:

1. Disable or enable a SNAT rule in one of the following ways:
   • If you want to enable or disable a SNAT rule in a firewall template, go to the SD-WAN → Firewall templates menu section, click the firewall template, and select the NAT → SNAT tab.
   • If you want to enable or disable a SNAT rule on a CPE device, go to the SD-WAN → CPE menu section, click the CPE device, select the Firewall settings → NAT → SNAT tab, and select the Override check box.

   A table of SNAT rules is displayed.

2. Click Disable or Enable next to the SNAT rule that you want to disable or enable.

   The SNAT rule is disabled or enabled.

3. In the upper part of the settings area, click Save to save the settings of the firewall template or CPE device.