Kaspersky SD-WAN

Managing L3 VPN transport services

To display the table of L3 VPN services, go to the Infrastructure menu section, click Management → Configuration menu next to the controller, and go to the L3 VPN services section. Information about L3 VPN services is displayed in the following columns of the table:

• Name is the of the L3 VPN service.
• Type is the topology type of the L3 VPN service.
• Inter-spoke through hub indicates whether communication is possible between spoke sites through the hub site:
  • Yes
  • No
• Endpoints is the information about the L3 interfaces that have been added to the L3 VPN service:
  • If the L3 interfaces are mapped to M2M services, the M2M service names are displayed.
  • If the L3 interfaces are mapped to service interfaces, the following information is displayed:
    • Names and DPIDs of the CPE devices on which the service interfaces were created
    • Numbers of OpenFlow ports which the service interfaces are mapped to
    • Quality of service rules specified for the service interfaces
    • Traffic filters specified for the service interfaces
  • IP prefixes of the L3 interfaces
  • MAC addresses of the L3 interfaces
  • Time period in seconds during which entries are kept in the ARP table on the controller
• Routes is the information about static routes that have been added to the L3 VPN service:
  • Destination IPv4 prefixes of static routes
  • Gateway IPv4 addresses for routing traffic packets to destination IPv4 prefixes of static routes
  • L3 interfaces behind which the destination IPv4 prefixes of static routes are
  • Metrics of the static routes
• DHCP servers are IPv4 addresses of DHCP servers specified for the L3 VPN service.
• Status is the status of the L3 VPN service:
  • Up
  • Down
• Errors are errors that occurred while the L3 VPN service was running.

The actions you can perform with the table are described in the Managing solution component tables instructions.